200-125 Exam
The Most recent Guide To 200-125 study guides Sep 2021
The Cisco 200-125 exam dumps consist of the training materials that happen to be easily realize and necessary to the 200-125 real exam. Our Cisco merchandise are really popular from the market and enjoy a high status. Many candidates possess achieved success by using Ucertify Cisco 200-125 exam questions and answers. Our own professionals provide some 200-125 questions which try to evaluate yourself in your own home and find out the particular weak aspects of your studies. All the Cisco Cisco 200-125 training materials are generally most genuine, accurate and logical. Our skilled experts maintain your 200-125 dumps up-to-date and verified ahead of publishing. You can be full of confidence in the Cisco 200-125 exam following preparing this with our Cisco online education course.
2021 Sep 200-125 test question
Q1. - (Topic 3)
What are three approaches that are used when migrating from an IPv4 addressing scheme to an IPv6 scheme. (Choose three.)
A. enable dual-stack routing
B. configure IPv6 directly
C. configure IPv4 tunnels between IPv6 islands
D. use proxying and translation to translate IPv6 packets into IPv4 packets
E. statically map IPv4 addresses to IPv6 addresses
F. use DHCPv6 to map IPv4 addresses to IPv6 addresses
Answer: A,C,D
Q2. - (Topic 7)
Scenario
Refer to the topology. Your company has decided to connect the main office with three other remote branch offices using point-to-point serial links.
You are required to troubleshoot and resolve OSPF neighbor adjacency issues between the main office and the routers located in the remote branch offices.
An OSPF neighbor adjacency is not formed between R3 in the main office and R5 in the Branch2 office. What is causing the problem?
A. There is an area ID mismatch.
B. There is a PPP authentication issue; a password mismatch.
C. There is an OSPF hello and dead interval mismatch.
D. There is a missing network command in the OSPF process on R5.
Answer: C
Q3. - (Topic 1)
Refer to the exhibit.
What two results would occur if the hub were to be replaced with a switch that is configured with one Ethernet VLAN? (Choose two.)
A. The number of collision domains would remain the same.
B. The number of collision domains would decrease.
C. The number of collision domains would increase.
D. The number of broadcast domains would remain the same.
E. The number of broadcast domains would decrease.
F. The number of broadcast domains would increase.
Answer: C,D
Q4. CORRECT TEXT - (Topic 7)
Answer: On the MGT Router:
Config t
Router eigrp 12
Network 192.168.77.0
Q5. - (Topic 1)
Refer to the exhibit.
After HostA pings HostB, which entry will be in the ARP cache of HostA to support this transmission?
A. Exhibit A
B. Exhibit B
C. Exhibit C
D. Exhibit D
E. Exhibit E
F. Exhibit F
Answer: A
Up to date 200-125 pdf exam:
Q6. - (Topic 4)
Refer to the exhibit.
C-router is to be used as a "router-on-a-stick" to route between the VLANs. All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway. What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Q7. - (Topic 4)
What is the effect of using the service password-encryption command?
A. Only the enable password will be encrypted.
B. Only the enable secret password will be encrypted.
C. Only passwords configured after the command has been entered will be encrypted.
D. It will encrypt the secret password and remove the enable secret password from the configuration.
E. It will encrypt all current and future passwords.
Answer: E
Q8. - (Topic 3)
The network administrator needs to address seven LANs. RIP version 1 is the only routing protocol in use on the network and subnet 0 is not being used. What is the maximum number of usable IP addresses that can be supported on each LAN if the organization is using one class C address block?
A. 8
B. 6
C. 30
D. 32
E. 14
F. 16
Answer: C
Q9. - (Topic 5)
A network engineer wants to allow a temporary entry for a remote user with a specific username and password so that the user can access the entire network over the Internet. Which ACL can be used?
A. standard
B. extended
C. dynamic
D. reflexive
Answer: C
Q10. - (Topic 2)
Which command enables RSTP on a switch?
A. spanning-tree uplinkfast
B. spanning-tree mode rapid-pvst
C. spanning-tree backbonefast
D. spanning-tree mode mst
Answer: B