200-125 Exam
Shortcuts To 200-125（101 to 110）
Want to know Examcollection 200-125 Exam practice test features? Want to lear more about Cisco CCNA Cisco Certified Network Associate CCNA (v3.0) certification experience? Study Highest Quality Cisco 200-125 answers to Far out 200-125 questions at Examcollection. Gat a success with an absolute guarantee to pass Cisco 200-125 (CCNA Cisco Certified Network Associate CCNA (v3.0)) test on your first attempt.
2021 Oct 200-125 exam fees
Q101. - (Topic 4)
Refer to the exhibit.
Based on the exhibited routing table, how will packets from a host within the 192.168.10.192/26 LAN be forwarded to 192.168.10.1?
A. The router will forward packets from R3 to R2 to R1.
B. The router will forward packets from R3 to R1 to R2.
C. The router will forward packets from R3 to R2 to R1 AND from R3 to R1.
D. The router will forward packets from R3 to R1.
Answer: C
Q102. - (Topic 2)
Which port state is introduced by Rapid-PVST?
A. learning
B. listening
C. discarding
D. forwarding
Answer: C
Q103. - (Topic 9)
Which spanning-tree protocol rides on top of another spanning-tree protocol?
A. MSTP
B. RSTP
C. PVST+
D. Mono Spanning Tree
Answer: A
Q104. - (Topic 4)
A network administrator is trying to add a new router into an established OSPF network. The networks attached to the new router do not appear in the routing tables of the other OSPF routers. Given the information in the partial configuration shown below, what configuration error is causing this problem?
Router(config)# router ospf 1
Router(config-router)# network 10.0.0.0 255.0.0.0 area 0
A. The process id is configured improperly.
B. The OSPF area is configured improperly.
C. The network wildcard mask is configured improperly.
D. The network number is configured improperly.
E. The AS is configured improperly.
F. The network subnet mask is configured improperly.
Answer: C
Q105. - (Topic 5)
Which statement describes the process of dynamically assigning IP addresses by the DHCP server?
A. Addresses are allocated after a negotiation between the server and the host to determine the length of the agreement.
B. Addresses are permanently assigned so that the hosts uses the same address at all times.
C. Addresses are assigned for a fixed period of time, at the end of the period, a new request for an address must be made.
D. Addresses are leased to hosts, which periodically contact the DHCP server to renew the lease.
Answer: D
Topic 6, Network Device Security
234. - (Topic 6)
Refer to exhibit.
A network administrator cannot establish a Telnet session with the indicated router. What is the cause of this failure?
A. A Level 5 password is not set.
B. An ACL is blocking Telnet access.
C. The vty password is missing.
D. The console password is missing.
Answer: C
Renovate 200-125 exam topics:
Q106. - (Topic 9)
Refer to the exhibit.
What is the effect of the given configuration?
A. It configures an inactive switch virtual interface.
B. It configures an active management interface.
C. It configures the native VLAN.
D. It configures the default VLAN.
Answer: A
Q107. - (Topic 9)
What are two reasons that duplex mismatches can be difficult to diagnose? (Choose two.)
A. The interface displays a connected (up/up) state even when the duplex settings are mismatched.
B. The symptoms of a duplex mismatch may be intermittent.
C. Autonegotiation is disabled.
D. Full-duplex interfaces use CSMA/CD logic, so mismatches may be disguised by collisions.
E. 1-Gbps interfaces are full-duplex by default.
Answer: A,B
Q108. - (Topic 7)
What are three reasons to collect Netflow data on a company network? (Choose three.)
A. To identify applications causing congestion.
B. To authorize user network access.
C. To report and alert link up / down instances.
D. To diagnose slow network performance, bandwidth hogs, and bandwidth utilization.
E. To detect suboptimal routing in the network.
F. To confirm the appropriate amount of bandwidth that has been allocated to each Class of Service.
Answer: A,D,F
Q109. - (Topic 2)
Which command can be used from a PC to verify the connectivity between hosts that connect through a switch in the same LAN?
A. ping address
B. tracert address
C. traceroute address
D. arp address
Answer: A
Q110. - (Topic 4)
Refer to the exhibit.
A network administrator configures a new router and enters the copy startup-config running-config command on the router. The network administrator powers down the router and sets it up at a remote location. When the router starts, it enters the system configuration dialog as shown. What is the cause of the problem?
A. The network administrator failed to save the configuration.
B. The configuration register is set to 0x2100.
C. The boot system flash command is missing from the configuration.
D. The configuration register is set to 0x2102.
E. The router is configured with the boot system startup command.
Answer: A