300-115 Exam
The Only Tip You Need: 300 115 vce
Your success in Cisco ccnp switch 300 115 is our sole target and we develop all our cisco 300 115 dumps braindumps in a way that facilitates the attainment of this target. Not only is our 300 115 vce study material the best you can find, it is also the most detailed and the most updated. ccnp 300 115 pdf Practice Exams for Cisco CCDP certprepare 300 115 are written to the highest standards of technical accuracy.
P.S. Free 300-115 bootcamp are available on Google Drive, GET MORE: https://drive.google.com/open?id=1VHsb6dx9nuEZoveat99_kZpaJRSN1wlZ
New Cisco 300-115 Exam Dumps Collection (Question 12 - Question 21)
Q12. Which two combinations of Ether Channel modes support the formation of an EtherChannel? (Choose two.)
A. desirable, passive
B. desirable, desirable
C. active, passive
D. passive, passive
E. active, desirable
Answer: B,C
Q13. What is the default port security violation.
A. log
B. shutdown
C. no change
D. error-disable
Answer: B
Q14. Which statement about HSRP, GLBP, and VRRP is true?
A. VRRP group members communicate using multicast address 224.0.0.102.
B. MAC address 0000.0c07.acOc indicates that default gateway redundancy is provided through GLBP.
C. HSRP group members communicate using multicast address 224.0.0.18.
D. GLBP uses UDP port 3222 (source and destination) for hello messages.
Answer: A
Q15. Refer to the exhibit.
Which two effects of this configuration are true? (Choose two.)
A. R1 becomes the active router
B. If R2 goes down, R1 becomes active but reverts to standby when R2 comes back online
C. Hello messages are sent to multicast address 224.0.0.5.
D. If R1 goes down, R2 becomes active but reverts to standby when R1 comes back online.
E. R1 goes down, R2 becomes active and remains the active device when R1 comes back online
F. R1 becomes the standby router.
Answer: A,E
Q16. An access switch at a remote location is connected to the spanning-tree root with redundant uplinks. A network engineer notices that there are issues with the physical cabling of the current root port. The engineer decides to force the secondary link to be the desired forwarding root port.
Which action accomplishes this task?
A. Change the link-type to point-to-point.
B. Enable Rapid Spanning Tree to converge using the secondary link.
C. Adjust the secondary link to have a lower priority than the primary link.
D. Apply a BPDU filter on the primary interface of the remote switches.
Answer: C
Q17. Refer to the exhibit.
Which two statements about the network environment of the device that generated this output are true? (Choose two.)
A. The local device has a higher priority setting than the active router.
B. The virtual IP address of the HSRP group is 10.1.1.1
C. If a router with a higher IP address and same HSRP priority as the active router becomes available, that router becomes the new active router 5 seconds later.
D. if the local device fails to receive a hello from the active router for more than 5 seconds, it can become the active router.
E. The hello and hold timers are set to custom values.
Answer: B,C
Q18. Which option is a Cisco recommended KSPAN configuration practice?
A. Use a different RSPAN VLAN for each session it configuring RSPAN on multiple switches.
B. Use only one destination port for each RSPAN session.
C. Define an RSPAN VLAN before configuring an RSPAN source or destination session.
D. Assign access ports to an RSPAN VLAN like any other campus VLAN
Answer: C
Q19. Which command enables root guard on a Cisco switch at location id:28468780 ?
A. Switch (config)#spanning-tree guard root
B. Switch (config-if)#spanning-tree guard-root
C. Switch (config-if)#spanning-tree root guard
D. Switch (config-if)#spanning-tree guard root
E. Switch (config)#spanning-tree root guard
Answer: D
Q20. Refer to the output below.
Which two effects of this configuration are true'? (Choose two.)
A. The device adds an 8-byte VLAN tag to data on VLAN 2
B. Data on VLAN 2 remains untagged
C. Data on VLANs 4, 6, and 8 remains untagged.
D. The device adds a 4-byte VLAN tag to data on VLAN 2 only.
E. The switch adds a 4-byte VLAN tag to data on VLANs 4. 6 and 8.
Answer: B,E
Q21. What VSS technology allows you to share downstream resources?
A. LACP
B. PAgP
C. MEC
D. EOA
Answer: C
P.S. Easily pass 300-115 Exam with 2passeasy Free Dumps & pdf vce, Try Free: https://www.2passeasy.com/dumps/300-115/ (364 New Questions)