we provide Highest Quality CompTIA SK0-004 practice question which are the best for clearing SK0-004 test, and to get certified by CompTIA CompTIA Server+. The SK0-004 Questions & Answers covers all the knowledge points of the real SK0-004 exam. Crack your CompTIA SK0-004 Exam with latest dumps, guaranteed!
Q1. A server technician in a datacenter configures a daemon to monitor the battery health in a UPS. Over a two day time period, the daemon generates a warning message. Which of the following represents the FIRST action that should be taken by the server technician?
A. Perform a test on the UPS batteries
B. Immediately replace the UPS batteries
C. Move the servers connected to the UPS to another existing UPS
D. Immediately replace the UPS with a new UPS
Answer: A
Q2. A system administrator has just performed a backup. Which of the following should the administrator perform to easily identify the backup tape?
A. Label the tape
B. Mount the tape in the drive
C. Place the tape in the rack
D. Update the site log
Answer: A
Q3. A technician working in the datacenter has finished racking a new 4U server into a new rack. Which of the following should the technician do to allow for hot/cold aisle containment?
A. Close the perforated floor tile in front of the new rack.
B. Reset the rack temperature and humidity control.
C. Install blanking panels in the rack.
D. Lower the temperature of the data center HVAC.
Answer: C
Q4. Users on a network segment report that they are unable to connect to a newly installed file server. The file server IP address settings are as follows:
IP address: 10.0.10.254
Subnet Mask: 255.255.255.0
Default Gateway: 10.10.10.1
Which of the following changes should the server administrator make?
A. Change the IP address on the server to 10.10.0.254.
B. Change the IP address on the server to 10.10.10.254.
C. Change the default gateway on the server to 10.10.10.254.
D. Change the subnet mask on the server to 255.255.0.0.
Answer: B
Q5. A hardware compatibility list recommends striping with double parity as storage for an application. In a test environment, a technician realizes that a different RAID level can be used to compensate for a limited number of available disks. Which of the following is the closest RAID level the technician should deploy while minimizing the number of disks and maintaining fault tolerance?
A. 0
B. 1
C. 5
D. 10
Answer: C
Q6. A number of users are indicating that access to a network file server is responding very slowly when reading or writing to the share. The server administrator notes that a drive has failed in a four-disk RAID 5 array. The array is running in a degraded state because no hot spare was configured. After replacing the failed disk, which of the following steps would be BEST to take to prevent slow response after a drive failure?
A. Add a drive to the array, but do not configure it as a hot spare.
B. Add an additional hard drive, and convert the volume to a RAID 6 configuration.
C. Add an additional hard drive, and convert the volume to a RAID 10 configuration.
D. Add a drive to the array, and configure it as a cold spare.
Answer: B
Q7. An administrator is developing a storage growth plan for a new file server. Which of the following should be implemented on the server so that storage growth is restricted?
A. Disk quotas
B. Disk compression
C. Automatic usage reports
D. Automatic defragmentation
Answer: A
Q8. An administrator needs to deploy 1000 servers in a short period of time. Which of the following deployment methods will expedite the OS installations?
A. Use disk duplicating software.
B. Use USB disk images to deploy servers.
C. Use a disk replicator.
D. Use PXE boot to retrieve an image.
Answer: D
Q9. A server administrator is configuring access control on a file server for an organization. The Human Resources manager is taking a leave of absence for three months, during which time an interim Human Resources manager will take over the duties of the position. Which of the following types of access control should be configured on the file server?
A. MAC
B. CBAC
C. DAC
D. RBAC
Answer: D
Q10. A technician troubleshootinga mail serverdeterminesthat theserver is low on available hard drive space and needs an additional hard drive installed. The server will need to be offline for the hardware installation. Which of the following troubleshooting steps should the technician do NEXT?
A. Notify impacted users of the scheduled maintenance.
B. Implement one change at a time.
C. Collect additional information.
D. Document findings, actions, and outcomes.
Answer: A