NEW QUESTION 1
Which set of action satisfy the requirement for multifactor authentication?

• A. The user swipes a key fob, then clicks through an email link
• B. The user enters a user name and password, and then clicks a notification in an authentication app on a mobile device
• C. The user enters a PIN into an RSA token, and then enters the displayed RSA key on a login screen
• D. The user enters a user name and password and then re-enters the credentials on a second screen

Answer: A

NEW QUESTION 2
Refer to the exhibit.

What does router R1 use as its OSPF router-ID?

• A. 10.10.1.10
• B. 10.10.10.20
• C. 172.16.15.10
• D. 192.168.0.1

Answer: B

NEW QUESTION 3
Drag and drop the AAA functions from the left onto the correct AAA services on the right

• A. Mastered
• B. Not Mastered

Answer: A

Explanation:

NEW QUESTION 4
Refer to the exhibit.

A network engineer must block access for all computers on VLAN 20 to the web server via HTTP All other computers must be able to access the web server Which configuration when applied to switch A accomplishes this task?

• A. Option A
• B. Option B
• C. Option C
• D. Option D

Answer: B

NEW QUESTION 5
Drag and drop the Cisco Wireless LAN Controller security settings from the left onto the correct security mechanism categories on the right.

• A. Mastered
• B. Not Mastered

Answer: A

Explanation:

NEW QUESTION 6
Drag and drop the descriptions of file-transfer protocols from the left onto the correct protocols on the right.

• A. Mastered
• B. Not Mastered

Answer: A

Explanation:

NEW QUESTION 7
Refer to the Exhibit.

After the switch configuration the ping test fails between PC A and PC B Based on the output for switch 1. which error must be corrected?

• A. There is a native VLAN mismatch
• B. Access mode is configured on the switch ports.
• C. The PCs are m the incorrect VLAN
• D. All VLANs are not enabled on the trunk

Answer: A

NEW QUESTION 8
Which statement identifies the functionality of virtual machines?

• A. Virtualized servers run most efficiently when they are physically connected to a switch that is separate from the hypervisor
• B. The hypervisor can virtualize physical components including CP
• C. memory, and storage
• D. Each hypervisor can support a single virtual machine and a single software switch
• E. The hypervisor communicates on Layer 3 without the need for additional resources

Answer: D

NEW QUESTION 9
Which two actions are performed by the Weighted Random Early Detection mechanism? (Choose two)

• A. It drops lower-priority packets before it drops higher-priority packets
• B. It can identify different flows with a high level of granularity
• C. It guarantees the delivery of high-priority packets
• D. It can mitigate congestion by preventing the queue from filling up
• E. IT supports protocol discovery

Answer: BD

NEW QUESTION 10
Which action is taken by a switch port enabled for PoE power classification override?

• A. When a powered device begins drawing power from a PoE switch port a syslog message is generated
• B. As power usage on a PoE switch port is checked data flow to the connected device is temporarily paused
• C. If a switch determines that a device is using less than the minimum configured power it assumes the device has failed and disconnects
• D. If a monitored port exceeds the maximum administrative value for power, the port is shutdown and err-disabled

Answer: C

NEW QUESTION 11
Which MAC address is recognized as a VRRP virtual address?

• A. 0000.5E00.010a
• B. 0005.3711.0975
• C. 0000.0C07.AC99
• D. 0007.C070/AB01

Answer: A

NEW QUESTION 12
Which type of address is the public IP address of a NAT device?

• A. outside global
• B. outsdwde local
• C. inside global
• D. insride local
• E. outside public
• F. inside public

Answer: C

NEW QUESTION 13
An engineer must configure a/30 subnet between two routers. Which usable IP address and subnet mask combination meets this criteria?

• A. Option A
• B. Option B
• C. Option C
• D. Option D

Answer: C

NEW QUESTION 14
When a site-to-site VPN is used, which protocol is responsible for the transport of user data?

• A. IKEv2
• B. IKEv1
• C. IPsec
• D. MD5

Answer: C

NEW QUESTION 15
Which IPv6 address block sends packets to a group address rather than a single address?

• A. 2000::/3
• B. FC00::/7
• C. FE80::/10
• D. FF00::/8

Answer: C

NEW QUESTION 16
Drag and drop the functions from the left onto the correct network components on the right

• A. Mastered
• B. Not Mastered

Answer: A

Explanation:

NEW QUESTION 17
An engineer configured an OSPF neighbor as a designated router. Which state verifies the designated router is in the proper mode?

• A. Exchange
• B. 2-way
• C. Full
• D. Init

Answer: B

NEW QUESTION 18
Which command automatically generates an IPv6 address from a specified IPv6 prefix and MAC address of an interface?

• A. ipv6 address dhcp
• B. ipv6 address 2001:DB8:5:112::/64 eui-64
• C. ipv6 address autoconfig
• D. ipv6 address 2001:DB8:5:112::2/64 link-local

Answer: C

NEW QUESTION 19
An organization has decided to start using cloud-provided services. Which cloud service allows the organization to install its own operating system on a virtual machine?

• A. platform-as-a-service
• B. software-as-a-service
• C. network-as-a-service
• D. infrastructure-as-a-service

Answer: D

NEW QUESTION 20
Which option about JSON is true?

• A. uses predefined tags or angle brackets () to delimit markup text
• B. used to describe structured data that includes arrays
• C. used for storing information
• D. similar to HTML, it is more verbose than XML

Answer: B

NEW QUESTION 21
What are two reasons that cause late collisions to increment on an Ethernet interface? (Choose two)

• A. when the sending device waits 15 seconds before sending the frame again
• B. when the cable length limits are exceeded
• C. when one side of the connection is configured for half-duplex
• D. when Carner Sense Multiple Access/Collision Detection is used
• E. when a collision occurs after the 32nd byte of a frame has been transmitted

Answer: CE

NEW QUESTION 22
Which configuration is needed to generate an RSA key for SSH on a router?

• A. Configure the version of SSH
• B. Configure VTY access.
• C. Create a user with a password.
• D. Assign a DNS domain name

Answer: B

NEW QUESTION 23
Refer to the exhibit.

Drag and drop the networking parameters from the left onto the correct values on the right. Check the answer below.

• A. Mastered
• B. Not Mastered

Answer: A

Explanation:

NEW QUESTION 24
......