300-510 Exam
Top Tips Of Replace 300-510 Sample Question
Pass4sure 300-510 Questions are updated and all 300-510 answers are verified by experts. Once you have completely prepared with our 300-510 exam prep kits you will be ready for the real 300-510 exam without a problem. We have Leading Cisco 300-510 dumps study guide. PASSED 300-510 First attempt! Here What I Did.
Check 300-510 free dumps before getting the full version:
NEW QUESTION 1
Refer to the exhibit. After troubleshooting an OSPF adjacency issue, routers 1, 2, and 3 have formed OSPF neighbor relationships. Which statement about the configuration is true?
- A. Router 2 receives a Type 5 LSAs from router 1 for its connected subnets
- B. Router 2 uses router 3 as the next hop for 192.168.0.0/24
- C. Router 2 uses router 1 as the next hop for 192.168.0.0/24
- D. Router 2 receives a Type 7 LSAs from router 3 for its connected subnets
Answer: A
NEW QUESTION 2
Refer to the exhibit. A network engineer implemented this segment routing configuration. Which statement about the output is true?
- A. This range conflicts with the segment routing local block range.
- B. The device must be reloaded for these ranges to be allocated and used.
- C. The default segment routing global block range is being used on this device.
- D. A nondefault segment routing global block range is being used on this device.
Answer: D
NEW QUESTION 3
Which feature is used in multicast routing to prevent loops?
- A. STP
- B. inverse ARP
- C. RPF
- D. split horizon
Answer: C
NEW QUESTION 4
What is used by SR-TE to steer traffic through the network?
- A. shortest path calculated by IGP
- B. dynamic rules
- C. path policy
- D. explicit maps
Answer: C
NEW QUESTION 5
Refer to the exhibit. Which task must you perform on interface g1/0/0 to complete the SSM implementation?
- A. configure OSPFv3
- B. enable CDP
- C. disable IGMP
- D. configure IGMPv3
Answer: D
NEW QUESTION 6
Refer to the exhibit. Which router does R1 install as an alternate next hop when trying to reach R3 if LFA is enabled?
- A. R5
- B. R3
- C. R4
- D. R2
Answer: D
NEW QUESTION 7
Which output from the show isis interface command helps an engineer troubleshoot an IS-IS adjacency problem on a Cisco IOS-XR platform?
- A. metric
- B. priority
- C. circuit type
- D. hello interval
Answer: D
NEW QUESTION 8
Refer to the exhibit. A network operator must inject a Level 1 route from XR2 (10.16.16.0/24) into the ISIS topology. Which configuration allows the injection in a way that XR3 and XR1 have a valid and working route for 10.16.16.0/24?
- A. A.
B.
C.
- B.
Answer: C
NEW QUESTION 9
Which command is used to enable BIDIR-PIM under global configuration mode for Cisco IOS XE Sofware?
- A. ip pim bidir-enable
- B. ipv4 pim bidir-enable
- C. ip multicast-routing
- D. ip pim bidir
Answer: A
NEW QUESTION 10
For which reason can two devices fail to establish an OSPF neighbor relationship?
- A. The two devices have different process IDs
- B. The two devices have different network types
- C. The two devices have different router IDs
- D. The two devices have the same area ID
Answer: B
NEW QUESTION 11
Refer to the exhibit. Router 1 has established an SR-TE tunnel with router 2. Which statement describes this configuration?
- A. Router 1 has a list of labels used to explicitly lay out a path to router 2.
- B. Router 1 and router 2 have a bidirectional tunnel set up with dynamic path selection.
- C. Router 1 is the head-end tunnel and has dynamically chosen a path to router 2.
- D. Router 2 is the head-end tunnel and has explicitly set a path to router 1.
Answer: C
NEW QUESTION 12
Refer to the exhibit. An engineer is addressing an IS-IS design issue which is running within the topology. All links are running on FastEthernet, except the link between R5 and R4, which is Gigabit Ethernet. Which statement about the design is true?
- A. R4 prefer to reach R5 using R1 as the next hop
- B. All links have equal cost if the default metric is used
- C. R5 prefers to use R4 as the next hop for all routes
- D. R1 prefer to use R5 as the next hop to reach R4
Answer: B
NEW QUESTION 13
Which statement about enabling segment routing for IGPs is true?
- A. Segment routing must first be enabled under then routing process and then globally
- B. Segment routing must first be enabled globally and then under the routing process
- C. Segment routing can be enabled only under the routing process
- D. Segment routing can be enabled only globally
Answer: B
NEW QUESTION 14
Refer to the exhibit. A network operator is getting the route for 10.11.11 0/24 from two upstream providers on #XR3. The network operator must configure #XR3 to force the 10.11.11.0/24 prefix to route via next hop of 10.0.0.9 as primary when available. Which of these can the operator use the routing policy language for, to enforce this traffic forwarding path?
- A. weight of 0 on the prefix coming from 192.168.0.2
- B. lower local preference on the prefix coming from 192.168.0.2
- C. higher local preference on the prefix coming from 192.168.0.1
- D. weight of 100 on the prefix coming from 192.168.0.1
Answer: C
NEW QUESTION 15
Which two statements about mapping multicast IP addresses to MAC addresses are true? (Choose two.)
- A. All mapped multicast MAC addresses begin with 0x0100.5E
- B. The router performs the mapping before it hands the packet off to a switch
- C. All multicast MAC addresses end with 0x0100.5E
- D. The mapping process may generate overlapping addresses, which can cause receivers to receive unwanted packets
- E. All destination MAC addresses begin with an octet of binary 1s
Answer: AD
NEW QUESTION 16
Refer to the exhibit. P1 and PE3 Cisco IOS XR routers are directly connected and have this configuration applied. The BGP session is not coming up. Assume that there is no IP reachability problem and both routers can open tcp port 179 to each other. Which two actions fix the issue? (Choose two.)
- A. Change MD5 to HMAC-SHA1-12
- B. Change MD5 to HMAC-ESP
- C. Change MD5 to SHA-1
- D. Change MD5 to HMAC-MD5
- E. Remove the send and accept lifetime under key 1
Answer: AD
NEW QUESTION 17
Refer to the exhibit. After troubleshooting BGP traffic steering issue, which action did the network operator take to achieve the correct effect of this configuration?
- A. Routes that have passed through AS 65517 have the local preference set to 150.
- B. Routes that have originated through AS 65517 have the local preference set to 150.
- C. Routes directly attached to AS 65517 have the local preference set to 150.
- D. Routes that have passed through AS 65517 have the local preference set to 150 and the traffic is denied.
Answer: A
NEW QUESTION 18
A network consultant is troubleshooting IS-IS instances to identify why a routing domains is having communication problems between the two instances. Which description of the possible cause of issues in the routing domain is true?
- A. The same interface cannot be advertised in two different IS-IS instances
- B. The IS-IS “ISP” and “ISP2” instances are unrelated and unable to intercommunicate
- C. The configured IS-IS NSEL value is not allowing the routing systems to establish a neighborship
- D. The interface mode ip router is-is command was not included in the script
Answer: A
NEW QUESTION 19
Refer to the exhibit. An engineer is troubleshooting an OSPF issue. Router 1 has a neighbor relationship with router 2. Only router 1 classful EIGRP routes can be seen on router 2. In order for all EIGRP routes to be redistributed correctly, which action should be taken?
- A. Router 1 must have the keyword subnets included in the redistribution command for all EIGRP routes to be redistributed.
- B. Router 1 must remove the AS number 1 from the redistribution command for all EIGRP routes to be redistributed.
- C. Router 1 must have the keyword ospf-metric included in the redistribution command for all EIGRP routes to be redistributed.
- D. Router 1 must have the keyword metric-type 1 included in the redistribution command for all EIGRP routes to be redistributed.
Answer: A
NEW QUESTION 20
After you change the IP address on an IOS XR router, you cannot ping the new address.
Which step did you forget to complete?
- A. commit the configuration
- B. roll back the configuration
- C. merge the configuration
- D. save the running configuration
Answer: A
NEW QUESTION 21
Refer to the exhibit. XR1 and XR2 are sending the prefix 10.11.11.0/24 to XR3. A configured policy on XR1 is incorrectly prepending AS path 11 11 12 12 onto this prefix. A network operator wants to add a policy onto XR3 that will not allow the falsely prepending prefix from being installed. Which policy configuration applied to the XR3 neighbor configuration for XR1 can accomplish this requirement without impact to other or future received routes?
- A.
- B.
C.
- C.
Answer: D
NEW QUESTION 22
Refer to the exhibit. Which statement about this configuration is true?
- A. Router 1 sends and receives multiple best paths from neighbor 192.168.1.1
- B. Router 1 sends up to two paths to neighbor 192.168.1.1 for all routes
- C. Router 1 receives up to two paths from neighbor 192.168.1.1 for all routes in the same AS
- D. Router 1 receives only the best path from neighbor 192.168.1.1
Answer: A
NEW QUESTION 23
For which reason can two BGP peers fail to establish a neighbor relationship?
- A. Their BGP send-community strings are misconfigured
- B. Their BGP timers are mismatched
- C. Their remote-as numbers are misconfigured
- D. They are both activated under an IPv4 address family
Answer: C
NEW QUESTION 24
......
100% Valid and Newest Version 300-510 Questions & Answers shared by 2passeasy, Get Full Dumps HERE: https://www.2passeasy.com/dumps/300-510/ (New 60 Q&As)