NEW QUESTION 1
<Quidway>display mac-address
-------------------------------------------------------------------------------
MAC Address VLAN/VSI Learned-From Type
-------------------------------------------------------------------------------
5489-98ec-f018 1/- GE0/0/13 dynamic
-------------------------------------------------------------------------------
Total items displayed = 1
Refer to the graphic. A switch attempts to forward a frame to the MAC destination 5489- 98ec-f01. Whatoperation will occur on the switch?

• A. The switch will send a request to obtain the MAC address of 5489-98ec-f011.
• B. The switch will report that the destination is unreachable and report this to the source.
• C. The switch will flood the frame via all ports, with exception of the port on which the frame was received.
• D. The switch will drop the frame because it does not have an entry in its MAC address table.

Answer: C

NEW QUESTION 2
In a network supporting IPv6, OSPF no longer supports which feature?

• A. multiple areas
• B. Router-ID
• C. authentication
• D. multicast updates

Answer: C

NEW QUESTION 3
Which of the following statements regarding single area OSPF are correct?(Choose three)

• A. An IP address needs to be configured on a loopback interface of each router before configuring an OSPFarea.
• B. The value of an area can be from 0.0.0.0 to 255.255.255.255.
• C. A single area can be configured using any supported area number.
• D. All of the links of the network need to be advertised in Area 0.

Answer: BCD

NEW QUESTION 4
On Huawei VRP platform, which of the following can be used to invoke the history command saved by thecommand line interface?(Choose two)
<choice ident="A">
<choice ident="B">
<choice ident="C">
<choice ident="D">

• A. Up cursor key < >
• B. Left cursor key < >
• C. Ctrl+P
• D. Ctrl+U

Answer: AC

NEW QUESTION 5
Refer to the graphic. Two peering routers are running RIP. RTA is using RIPv1 to advertise its routes, whileRTB is using RIPv2 to advertise the route 1.1.1.1/32. How will the route 1.1.1.1/32 appear in the IP routingtable of RTA?

• A. This route will not appear in the IP routing table of RTA.
• B. This route will appear in the IP routing table of RTA as 1.0.0.0/8.
• C. This route will appear in the IP routing table of RTA as 1.0.0.0/24.
• D. This route will appear in the IP routing table of RTA as 1.0.0.0/32.

Answer: D

NEW QUESTION 6
Refer to the graphic. R1,R2 and R3 are running RIPv1. R1 and R3 both advertise 172.16.0.0 to the RIPnetwork. How will this affect R2?

• A. R2 will not have a route to the networks 172.16.1.0/24 and 172.16.2.0/24
• B. R2 will only have a route to 172.16.1.0/24
• C. R2 will only have a route to 172.16.2.0/24
• D. R2 will have a route to both networks 172.16.1.0/24 and 172.16.2.0/24, but some packets for these destinations will be lost.

Answer: D

NEW QUESTION 7
Refer to the graphic. RTA is a PPPoE client, and following transmission of PADI, Server A responds withPADO packets to RTA. Which distribution method is used for sending PADO packets?

• A. unicast
• B. multicast
• C. broadcast
• D. anycast

Answer: A

NEW QUESTION 8
<Huawei>reset saved-configuration
Warning: The action will delete the saved configuration in the device. The configuration will be erased to reconfigure. Continue? [Y/N]:
Refer to the configuration output. Which of the following statements are true? (Select two answers)

• A. A user should enter ‘Y’ when wishing to clear the saved configuration file.
• B. The saved-configuration file that the device starts with can be erased.
• C. The saved-configuration will be deleted after typing N
• D. The saved-configuration file will be replaced with the current-configuration.

Answer: AB

NEW QUESTION 9
The Eth-Trunk frame forwarding mechanism used to prevent changes in the data sequence forwards framesbased on which of the following parameters?

• A. The same source or destination IP address
• B. The same source or destination MAC address.
• C. The same protocol type.
• D. The same source or destination port number.

Answer: AB

NEW QUESTION 10
Which of the following steps are necessary to configure OSPF on a Huawei router?(Choose three)

• A. Configuration of a router ID
• B. Enabling of an OSPF process
• C. Specifying an OSPF area
• D. Configuration of the network segments within each area

Answer: BCD

NEW QUESTION 11
What are the three protocol components defined by PPP?(Choose three).

• A. Data encapsulation.
• B. LCP
• C. NCP
• D. IPCP

Answer: ABC

NEW QUESTION 12
Which of the following authentication methods are supported for Telnet users?(Choose three)

• A. Password authentication
• B. AAA local authentication
• C. MD5 authentication
• D. No authentication

Answer: ABD

NEW QUESTION 13
An administrator wishes to update the VRP software of company’s AR2200 router. How can this be achieved?(Choose three)

• A. The administrator can use FTP to transfer the VRP software, with the AR2200 router as the FTP client.
• B. The administrator can use FTP to transfer the VRP software, with the AR2200 router as the FTP server.
• C. The administrator can use TFTP to transfer the VRP software, with the AR2200 router as the TFTP server.
• D. The administrator can use TFTP to transfer the VRP software, with the AR2200 router as the TFTP client.

Answer: ABD

NEW QUESTION 14
How many probe packets are sent for each TTL value by default when"tracert" is used to detect the path alongwhich packet is sent from source to destination?

• A. 3
• B. 4
• C. 6
• D. 8

Answer: A

NEW QUESTION 15
A host has established a telnet connection with the router attached to interface G0/0/0. Which of the followingstatements are correct?(Choose two)

• A. The destination address of a frame sent by the host will be the MAC address of the router interface.
• B. The destination address of a frame will be the MAC address of the switch interface.
• C. The destination port number in a segment header will have a value of 80.
• D. The destination IP address of a packet will be the IP address of the network interface of the router.

Answer: AD

NEW QUESTION 16
The network administrator attempts to add interface G0/0/1 on Switch A to Eth-trunk 1, however the commandfails. Which of the following may cause this?

• A. The interface is operating in half-duplex mode.
• B. The interface has been shutdown.
• C. The interface is already associated with another Eth-trunk.
• D. The interface is an access port.

Answer: CD

NEW QUESTION 17
Which of the following formats represent an accurate condensing of the IPv6 address2031:0000:720C:0000:0000:09E0:839A:130B?(Choose two).

• A. 2031:0:720C:0:0:9E0:839A:130B
• B. 2031:0:720C:0:0:9E:839A:130B
• C. 2031::720C::9E0:839A:130B
• D. 2031:0:720C::9E0:839A:130B

Answer: AD

NEW QUESTION 18
Ping 10.0.0.2: 56 data bytes, press CTRL_C to break
Reply from 10.0.0.2: bytes=800 Sequence=1 ttl=255 time=2 ms
Reply from 10.0.0.2: bytes=800 Sequence=2 ttl=255 time=10 ms
--- 10.0.0.2 ping statistics --- 2 packet(s) transmitted
2 packet(s) received
0.00% packet loss
round-trip min/avg/max = 2/6/10 ms
A network administrator uses the ping command to test connectivity to the destination
10.0.0.2 on a HuaweiAR series router. Which statement regarding the output is correct?

• A. The network administrator used the command ping -c 2 -s 800 10.0.0.2
• B. The network administrator used the command ping -a 2 -v 800 10.0.0.2
• C. The path between the source and destination is not OK.
• D. The network administrator changed the default TTL value.

Answer: A

NEW QUESTION 19
Refer to the graphic. An administrator has configured OSPF on the two routers, following which he thenimplements the command silent-interface s0/0/1 on RTA. What effect will this command have on the network?(Choose two)

• A. The link information advertised by RTB will be maintained in the Link State Database of RTA.
• B. The OSPF neighbor relationship will fail between two routers.
• C. The configuration will not affect the OSPF neighbor relationship between the two routers.
• D. The link information advertised by RTB will no longer be maintained in the Link State Database of RTA.

Answer: BD

NEW QUESTION 20
The network administrator wishes to transmit data between two endstations. The network interfacecards ofboth devices operates at 100Mbps however one supports half duplex while the other uses full duplex mode.
What will occur as a result?

• A. The end stations cannot communicate.
• B. The end stations can communicate, but data may be lost during transmission of large amounts of traffic.
• C. The end stations will operate normally
• D. The end stations can communicate, but speed is different during transmission of large amounts of traffic.

Answer: B

NEW QUESTION 21
Which of the following commands can be used to display mapping relationship between network address andDLCI?

• A. display fr interface
• B. display fr
• C. display fr map-info
• D. display fr brief

Answer: C

NEW QUESTION 22
Which of the following statements regarding the verification of IP connectivity are false?(Choose three)

• A. The ping 127.0.0.1 command can be used to check whether the network cable is correctly inserted into thehost’s Ethernet port.
• B. The ping command with the host IP address as the destination can be used to verify that the TCP/IPprotocol suite is functioning correctly.
• C. The ping command can be used to verify connectivity between the host and the local gateway.
• D. The command “ipconfig /release” can be used to check connectivity problems between the host and thelocal gateway.

Answer: ABD

NEW QUESTION 23
What is the meaning of 200 in the command "fr map ip 10.1.1.2 200"?

• A. remote logical channel ID
• B. local DLCI
• C. remote interface ID
• D. remote node ID

Answer: B

NEW QUESTION 24
Refer to the graphic. IPsec VPN uses ESP to encrypt which fields?

• A. TCP, Data and ESP Trailer
• B. ESP, TCP and Data
• C. ESP, TCP, Data and ESP Trailer
• D. ESP, TCP, Data, ESP Trailer and ESP Auth

Answer: A

NEW QUESTION 25
FTP may be used to upgrade a router's VRP image. Which of the following transmission modes should beused to achieve this?

• A. binary mode
• B. ASCII mode
• C. byte mode
• D. letter mode

Answer: A

NEW QUESTION 26
[RTA]acl 2001
[RTA-acl-basic-2001]rule deny source 172.16.1.1 0.0.0.0
[RTA-acl-basic-2001]rule deny source 172.16.0.0 0.255.0.0
Refer to the configuration output. Which of the following statements are correct regarding the configuration ofthe ACL on RTA?(Choose two).

• A. Packets from network 172.16.1.1/32 will be denied.
• B. Packets from network 172.16.1.0/24 will be denied
• C. Packets from network 172.17.1.0/24 will be denied
• D. Packets from network 172.18.0.0/16 will be denied.

Answer: AD

NEW QUESTION 27
With what kind of routers does a DRother router exchange link state information and route information?(Choose two)

• A. DR
• B. BDR
• C. DRother
• D. All OSPF neighbors

Answer: AB

NEW QUESTION 28
The network administrator needs to configure static NAT on RTA, in order to allow Host A to communicate withHost C. Which command is correct?

• A. [RTA-Serial1/0/1]nat outbound 200.1.1.10
• B. [RTA-Serial1/0/1]nat static global 200.1.1.10 inside 192.168.1.0
• C. [RTA-Serial1/0/1]nat static global 192.168.1.1 inside 200.1.1.10
• D. [RTA-Serial1/0/1]nat static global 200.1.1.10 inside 192.168.1.1

Answer: D

NEW QUESTION 29
In a network supporting IPv6, OSPF no longer supports which feature?

• A. multiple areas
• B. Router-ID
• C. authentication
• D. multicast updates

Answer: C

NEW QUESTION 30
Two end stations in a point-to-point network perform address resolution. Which of the following statements iscorrect?

• A. The destination address of an ARP request from each station will be a unicast MAC address.
• B. The destination address of an ARP request from each station will be a broadcast IP address.
• C. The destination address of an ARP reply from each station will be a unicast MAC address
• D. The destination address of an ARP reply from each station will be a broadcast MAC address.

Answer: C

NEW QUESTION 31
......