200-310 Exam
ccda 200 310 official cert guide? Tips for success
Certleader offers free demo for cisco 200 310 exam. "DESGN Designing for Cisco Internetwork Solutions", also known as cisco 200 310 exam, is a Cisco Certification. This set of posts, Passing the Cisco ccda 200 310 official cert guide pdf exam, will help you answer those questions. The ccda 200 310 official cert guide download Questions & Answers covers all the knowledge points of the real exam. 100% real Cisco ccda 200 310 official cert guide pdf exams and revised by experts!
P.S. Accurate 200-310 bible are available on Google Drive, GET MORE: https://drive.google.com/open?id=1bPeAYB_55eCBMyIc2cOoIKP5xvaBjtPL
New Cisco 200-310 Exam Dumps Collection (Question 7 - Question 16)
New Questions 7
At which layer of the network should you perform traffic filtering and Qos classification?
A. session
B. distribution
C. application
D. core
Answer: C
New Questions 8
What are two benefits of a structured IPv4 addressing scheme? (Choose two.)
A. reduces routing table size
B. provides increased security
C. allows for address translation to be performed
D. improves manageability and troubleshooting
E. increases high availability
Answer: A,D
New Questions 9
Application servers require load balancing and security services. Where in the data center network should these services be provisioned?
A. core
B. aggregation
C. Layer 3 access
D. distribution
Answer: B
New Questions 10
Which one of the following represent correct IPv6 Global Unicast address format?
A. 48bit(Global Prefix)+16bit(Subnet ID)+64bit(Interface ID)
B. 16bit(Subnet ID)+ 48bit(Global Prefix)+64bit(Interface ID)
C. 64bit(Interface ID)+16bit(Subnet ID)+ 48bit(Global Prefix)
D. 64bit(Interface ID)+ 48bit(Global Prefix)+16bit(Subnet ID)
Answer: A
New Questions 11
Which option is an advantage of a Layer 3 access model over the traditional Layer 2 access model ?
A. increased neighbor adjacencies
B. faster convergence
C. reduced resources on the router
D. reduced size of routing table
Answer: B
New Questions 12
A network engineer has finished designing and implementing a new network. What two protocols would they use to gain insight into the network and determine the components that require optimization? (Choose two.)
A. CDP
B. NetFlow
C. ICMP Echo
D. NMAP
E. SNMP
Answer: B,E
New Questions 13
Which DHCP option do you need to configure to ensure that an LWAP can communicate with the Cisco WLC in a different subnet?
A. 7
B. 19
C. 43
D. 150
Answer: C
New Questions 14
Which VPN tunneling technology supports IP multicast?
A. DMVPN spoke-to-spoke
B. Cisco Easy VPN
C. IPsec direct encapsulation spoke-to-spoke
D. IPsec direct encapsulation hub-and-spoke
Answer: A
New Questions 15
In the traditional hierarchical LAN design, which two statements about the distribution layer are true? (Choose Two)
A. It uses Layer 2 switching only.
B. It typically is connected directly to the internet
C. it aggregates data from the access layer
D. Policy is omplemented at this layer
E. It provides users direct access to the network.
Answer: C,D
Explanation: http://www.ciscopress.com/articles/article.asp?p=2202410&seqNum=4
New Questions 16
With deterministic Wireless LAN Controller redundancy design, the different options available to the designer have their own strengths. Which statement is an example of such a strength?
A. Dynamic load balancing, or salt-and-pepper access point design, avoids the potential impact of oversubscription on aggregate network performance.
B. N+N redundancy configuration allows logically grouping access points on controllers to minimize intercontroller roaming events.
C. N+N+1 redundancy configuration has the least impact to system management because
all of the controllers are colocated in an NOC or data center.
D. N+1 redundancy configuration uses Layer 3 intercontroller roaming, maintaining traffic on the same subnet for more efficiency.
Answer: B
Recommend!! Get the Accurate 200-310 dumps in VCE and PDF From Dumpscollection, Welcome to download: http://www.dumpscollection.net/dumps/200-310/ (New 287 Q&As Version)