Q1. In which operation mode does the AP act as a dedicated sensor for location-based and intrusion detection services?

A. monitor mode

B. promiscuous mode

C. discovery mode

D. sniffer mode

Q2. Refer to the exhibit.

On which router should you configure redistribution?

A. Router 1

B. Router 2

C. Router 3

D. Router 4

E. Router 5

Q3. You want to gather as much detail as possible during a network audit, to include data time stamping across a large number of interfaces, customized according to interface, with a minimal impact on the network devices themselves. Which tool would you use to meet these requirements?

A. RMON

B. SNMPv3

C. NetFlow

D. Cisco Discovery Protocol

Q4. Which benefit is an advantage of route summarization?

A. It reduces the size of the routing table.

B. It causes routes to be updated more frequently.

C. It lowers the cost metric.

D. It enables neighbor discovery.

Q5. An organization is deciding what routing protocol to use throughout their network. What must be considered if routing is to be performed at the access layer?

A. reduced scalability of the network when introducing a large number of switch blocks into the routing table

B. centralized management of access control lists at the distribution layer

C. reliability when implementing routing over spanning-tree at the access layer

D. performance differences between core, distribution and access layer equipment

Q6. While designing a remote access VPN, a customer has requested three different levels of access to be granted for administrators, employees, and partners. Which three access policies must be configured for the three groups? (Choose Three)

A. Partners are centrally authenticated with limited network access controlled with ACLs.

B. Adminitrative users have local credentials with full access to the internal infrastructure.

C. Administrative users are centrally authenticated with fill access to the internal infrastructure.

D. Employee are centrally authenticated with limited network access controlled with ACLs.

E. Employees are centrally authenticated with full access to the internal infrastructure.

F. Partners are centrally authenticated with full access to the internal infrastructure.

Q7. A network design engineer is seeking a dynamic routing protocol that supports fast convergence in a Cisco environment. What protocol allows for this?

A. EIGRP

B. OSPF

C. RIP

D. BGP

E. IS-IS

Q8. What type of topology supports WAN redundancy when a balance is required between cost, high availability, and performance?

A. partial meshed

B. full meshed

C. star

D. ring

E. hub-and-spoke

F. bus

G. point-to-point

Q9. Which option is an example of a fixed two-level hierarchical routing protocol?

A. OSPF

B. RIPv2

C. EIGRP

D. static routes

Q10. What information should be utilized to identify network applications that are running on an existing network infrastructure?

A. customer information

B. existing documentation

C. traffic analysis

D. external feedback

E. user feedback