getcertified4sure.com

640-692 Exam

Simulation 640-692 Dump 2021




Pass4sure offers free demo for 640-692 exam. "Supporting Cisco routing and Switching Network Devices", also known as 640-692 exam, is a Cisco Certification. This set of posts, Passing the Cisco 640-692 exam, will help you answer those questions. The 640-692 Questions & Answers covers all the knowledge points of the real exam. 100% real Cisco 640-692 exams and revised by experts!

Online 640-692 free questions and answers of New Version:

NEW QUESTION 1
What are two possible causes if an Ethernet interface is up and the line protocol is down? (Choose two)

  • A. The Ethernet cable might not be attached properly
  • B. There is a speed or duplex mismatch with the remote device
  • C. The Ethernet interface has been manually disabled
  • D. There is a Layer 2 mismatch in the encapsulation type
  • E. Keepalives are not being received by the local device

Answer: BD

NEW QUESTION 2
Which sequence begins a unique local IP address in binary notation?

  • A. 1111110
  • B. 1111111
  • C. 00000000
  • D. 1111100

Answer: A

NEW QUESTION 3
Which two of the following CLI operating modes, by default, allow you to copy a Cisco IOS image to flash memory from TFTP server? (Choose two)

  • A. User EXEC
  • B. Privileged EXEC
  • C. ROMMON
  • D. Global configuration

Answer: BC

NEW QUESTION 4
Refer to the exhibit.
640-692 dumps exhibit
What is the result of setting the no login command?

  • A. Telnet access is denied.
  • B. Telnet access requires a new password at the first login.
  • C. Telnet access requires a new password.
  • D. no password is required for telnet access.

Answer: D

NEW QUESTION 5
Which command is necessary to permit SSH or Telnet access to a cisco switch that is otherwise configured for these vty line protocols?

  • A. transport type all
  • B. transport output all
  • C. transport preferred all
  • D. transport input all

Answer: D

NEW QUESTION 6
DRAG DROP
640-692 dumps exhibit

  • A. Mastered
  • B. Not Mastered

Answer: A

Explanation:
The correct answer is: Router(boot)# Router(config-if)# Router(config)# Router#
Rommon> Router>

NEW QUESTION 7
Which type if memory is used to permanently store the Cisco IOS software?

  • A. Flash
  • B. DRAM
  • C. SRAM
  • D. NVRAM

Answer: A

NEW QUESTION 8
At the interface configuration prompt, which command returns you to the main configuration prompt?

  • A. Ctrl-Z
  • B. end
  • C. exit
  • D. quit

Answer: C

NEW QUESTION 9
What are two ways to open Microsoft Notepad on a Windows-based computer? (Choose two)

  • A. Start > Run Enter Notepad and 'Ink OK
  • B. Start > Control Panel > Notepad
  • C. Start > All Programs > Notepad
  • D. Start > All Programs > Accessories > Notepad
  • E. Start > All Programs > Microsoft Office > Notepad

Answer: AD

NEW QUESTION 10
Which command initiates copying the saved configuration of a Cisco device to a TFTP server?

  • A. copy running-config tftp
  • B. copy startup-config tftp
  • C. copy tftp running-config
  • D. copy tftp startup-config

Answer: B

NEW QUESTION 11
Which two commands display the saved configuration file? (Choose two)

  • A. show configuration
  • B. show file system
  • C. show running-config
  • D. show startup-config

Answer: AD

NEW QUESTION 12
What one of the feature is associated with single-mode fiber-optic cable?

  • A. a single strand of glass fiber
  • B. stored less bandwidth
  • C. cost is less than multimode fiber
  • D. operates over less distance than multimode fiber

Answer: A

NEW QUESTION 13
Which two pieces of information can be determined about a neighbor device from the CLI command show cdp neighbor? (Choose two)

  • A. device ID
  • B. IP address
  • C. platform
  • D. uptime

Answer: AC

NEW QUESTION 14
Which Ethernet interface command is present when you boot a new Cisco router for the first time?

  • A. speed 100
  • B. shutdown
  • C. ip address 192.168.1.1 255.255.255.0
  • D. duplex half

Answer: B

NEW QUESTION 15
Which two pairs of LAN Ethernet devices use an RJ-45 Straight-through cable? (Choose two)

  • A. Switch to switch
  • B. Switch to router
  • C. Switch to server
  • D. Router to router
  • E. Switch to hub

Answer: BC

NEW QUESTION 16
The pins and RJ-45 are numbered from 1 through 8. With the material points of the plug facing toward you, pin 1 is the leftmost pin. Which two sets are looped on an RJ-45 T1 loopback plug? (Choose two)

  • A. Pins 1 and 4
  • B. Pins 1 and 7
  • C. Pins 2 and 5
  • D. Pins 2 and 8
  • E. Pins 1 and 5
  • F. Pins 2 and 7

Answer: AC

NEW QUESTION 17
Refer to the exhibit.
640-692 dumps exhibit
Which user-mode password has just been set?

  • A. Telnet
  • B. Auxiliary
  • C. SSH
  • D. Console

Answer: A

NEW QUESTION 18
TFTP is a simple protocol files, such as a Cisco IOS or configuration file, from one device to another. Which device cannot be configured to be used as a TFTP server?

  • A. Cisco router
  • B. Cisco switch
  • C. Computer
  • D. Modem
  • E. Cisco wireless LAN

Answer: D

NEW QUESTION 19
While performing password recovery on a Cisco device, the configuration register should be which value in order to bypass loading the startup configuration?

  • A. 0x2102
  • B. 0x2112
  • C. 0x2122
  • D. 0x2142

Answer: D

NEW QUESTION 20
A null modem cable uses which adapter type?

  • A. RJ-11
  • B. RJ-45
  • C. RS-323
  • D. RS-232
  • E. USB

Answer: B

NEW QUESTION 21
What are two features that are associated with single-mode fiber-optic cable? (Choose two.)

  • A. a single strand of glass fiber
  • B. carries higher bandwidth than multimode fiber
  • C. cost is less than multimode fiber
  • D. operates over less distance than multimode fiber

Answer: AB

NEW QUESTION 22
Which two of the following statements are true? (Choose two)

  • A. OEM products that are built for Cisco never get a Cisco logo applied.
  • B. The Cisco logo, old or new, can be found on the front bezel of all Cisco rack-mountable or desktop products.
  • C. Serial numbers are attached by label on all Cisco field-replaceable parts.
  • D. At the network module level, the model number is the same as the part number.

Answer: BD

NEW QUESTION 23
Which type of memory stores the startup configuration file for the Cisco device?

  • A. Flash
  • B. NVRAM
  • C. RAM
  • D. ROM

Answer: B

NEW QUESTION 24
Which of the following describes the roles of devices in a WAN? (Choose three.)

  • A. A CSU/DSU terminates a digital local loop.
  • B. A modem terminates a digital local loop.
  • C. A CSU/DSU terminates an analog local loop.
  • D. A modem terminates an analog local loop.
  • E. A router is commonly considered a DTE device.
  • F. A router is commonly considered a DCE device.

Answer: ADE

NEW QUESTION 25
Which windows-based text editor is preferred when working with a simple text document such as a Cisco configuration?

  • A. Microsoft Excel
  • B. Microsoft Word
  • C. Microsoft Notepad
  • D. Microsoft Access

Answer: C

NEW QUESTION 26
......

100% Valid and Newest Version 640-692 Questions & Answers shared by Certleader, Get Full Dumps HERE: https://www.certleader.com/640-692-dumps.html (New 92 Q&As)