NEW QUESTION 1
Refer to the exhibit.

Of which cable type this an example?

• A. RJ-45 straight-through
• B. RJ-45
• C. RJ-45 rollover
• D. RJ-11
• E. RJ-45 crossover

Answer: E

NEW QUESTION 2
How does a Cisco switch respond if you boot it without a valid configuration in the NVRAM?

• A. it enters setup mode.
• B. it uses the running –configuration
• C. It prompts you to restore the startup configuration
• D. it enters user EXEC mode.

Answer: B

NEW QUESTION 3
Which command displays the configuration register setting?

• A. show config-register
• B. show flash
• C. show running-config
• D. show version

Answer: D

NEW QUESTION 4
Refer to the exhibit.

Which three statements correctly describe Network Device A? (Choose three.)

• A. With a network wide mask of 255.255.255.128, each interface does not require an IP address.
• B. With a network wide mask of 255.255.255.128, each interface does require an IP address on a unique IP subnet.
• C. With a network wide mask of 255.255.255.0, must be a Layer 2 device for the PCs to communicate with each other.
• D. With a network wide mask of 255.255.255.0, must be a Layer 3 device for the PCs to communicate with each other.
• E. With a network wide mask of 255.255.254.0, each interface does not require an IP address.

Answer: BDE

NEW QUESTION 5
Which two commands are used to set the configuration register value? (Choose two)

• A. Router(config)#config-register 0x2102
• B. Router(config)#confreg 0x2102
• C. rommon>config-register 0x2102
• D. rommon>confreg 0x2102
• E. Router(config)#configuration-register 0x2102

Answer: AD

NEW QUESTION 6
Which command indicates the amount of memory (NVRAM, RAM, and flash) in a Cisco device?

• A. show diag
• B. show environment
• C. show inventory
• D. show version

Answer: D

NEW QUESTION 7
Which two of the following statements are true about a switch? (Choose two)

• A. It is a repeater.
• B. It is a data link layer device.
• C. It will forward the frame out all ports when it receives a broadcast from a host.
• D. It reads the destination MAC address to forward traffic out the appropriate port.
• E. It acts as an amplifier.

Answer: BD

NEW QUESTION 8
Which two of the following are component of WAN connection? (Choose two)

• A. router
• B. switch
• C. CSU/DSU
• D. Hub
• E. Bridge

Answer: AC

NEW QUESTION 9
Which two of the following are features of NVRAM on a Cisco device? (Choose two)

• A. Stores startup configuration
• B. Stores running configuration
• C. Stores routing tables
• D. Stores decompressed IOS software image
• E. Erased when device is rebooted
• F. Not erased when device is rebooted

Answer: AF

NEW QUESTION 10
Which two modules can be plugged into internal advanced integration module (AIM) slots on a Cisco router? (Choose two)

• A. Virtual Private Network Module
• B. Intrusion Detection System Module
• C. Packet Voice Digital Signal Processor Module
• D. LAN Switching Module
• E. Voice Interface Module

Answer: AB

NEW QUESTION 11
Which of the following best describes the cable that is used to connect a laptop to an Ethernet port on a Cisco router?

• A. Crossover
• B. Straight-through
• C. Fiber
• D. Rollover

Answer: A

NEW QUESTION 12
Refer to the exhibit.

Into which port do you insert the card?

• A. ATM
• B. Gigabit Ethernet
• C. Serial
• D. Ethernet

Answer: B

NEW QUESTION 13
Refer to the exhibit.

What is the result of setting the no login command?

• A. Telnet access is denied.
• B. Telnet access requires a new password at the first login.
• C. Telnet access requires a new password.
• D. no password is required for telnet access.

Answer: D

NEW QUESTION 14
DRAG DROP

• A. Yes
• B. Not Mastered

Answer: A

NEW QUESTION 15
Which two of the following statements are true? (Choose two)

• A. Because FTP usually requires authentication, a Cisco router must be configured with the appropriate username and password.
• B. FTP uses UDP as its transport protocol.
• C. The copy running-config ftp: command is used to copy a configuration file from an FTP server to the running configuration.
• D. A router can act as an FTP server.
• E. FTP can be used to load Cisco IOS software to router in ROMMON mode.

Answer: AD

NEW QUESTION 16
Which of the following command display the saved configuration file?

• A. show configuration
• B. show file system
• C. show running-config
• D. start config

Answer: A

NEW QUESTION 17
......