getcertified4sure.com

how to use nse4 fortinet




we provide Realistic Fortinet nse4 exam dump free download which are the best for clearing nse4 exam test, and to get certified by Fortinet Fortinet Network Security Expert 4 Written Exam (400). The fortinet nse4 dumps Questions & Answers covers all the knowledge points of the real nse4 dumps exam. Crack your Fortinet fortinet nse4 exam Exam with latest dumps, guaranteed!

Q1. - (Topic 22) 

Which is one of the conditions that must be met for offloading the encryption and decryption of IPsec traffic to an NP6 processor? 

A. No protection profile can be applied over the IPsec traffic. 

B. Phase-2 anti-replay must be disabled. 

C. Both the phase 1 and phases 2 must use encryption algorithms supported by the NP6. 

D. IPsec traffic must not be inspected by any FortiGate session helper. 

Answer: C


Q2. - (Topic 14) 

The exhibit shows the Disconnect Cluster Member command in a FortiGate unit that is part of a HA cluster with two HA members. 

What is the effect of the Disconnect Cluster Member command as given in the exhibit. (Choose two.) 

A. Port3 is configured with an IP address for management access. 

B. The firewall rules are purged on the disconnected unit. 

C. The HA mode changes to standalone. 

D. The system hostname is set to the unit serial number. 

Answer: A,C 


Q3. - (Topic 14) 

Which of the following sequences describes the correct order of criteria used for the selection of a master unit within a FortiGate high availability (HA) cluster when override is disabled? 

A. 1. port monitor, 2. unit priority, 3. up time, 4. serial number. 

B. 1. port monitor, 2. up time, 3. unit priority, 4. serial number. 

C. 1. unit priority, 2. up time, 3. port monitor, 4. serial number. 

D. 1. up time, 2. unit priority, 3. port monitor, 4. serial number. 

Answer:


Q4. - (Topic 15) 

Review the IPsec phase 1 configuration in the exhibit; then answer the question below. 

Which statements are correct regarding this configuration? (Choose two.) 

A. The remote gateway address on 10.200.3.1. 

B. The local IPsec interface address is 10.200.3.1. 

C. The local gateway IP is the address assigned to port1. 

D. The local gateway IP address is 10.200.3.1. 

Answer: A,C 


Q5. - (Topic 14) 

Which of the following statements are correct about the HA command diagnose sys ha reset-uptime? (Choose two.) 

A. The device this command is executed on is likely to switch from master to slave status if override is disabled. 

B. The device this command is executed on is likely to switch from master to slave status if override is enabled. 

C. This command has no impact on the HA algorithm. 

D. This command resets the uptime variable used in the HA algorithm so it may cause a 

new master to become elected. 

Answer: A,D 


Q6. - (Topic 2) 

Which is an advantage of using SNMP v3 instead of SNMP v1/v2 when querying a FortiGate unit? 

A. MIB-based report uploads. 

B. SNMP access limited by access lists. 

C. Packet encryption. 

D. Running SNMP service on a non-standard port is possible. 

Answer:


Q7. - (Topic 16) 

Review the IPS sensor filter configuration shown in the exhibit 

Based on the information in the exhibit, which statements are correct regarding the filter? (Choose two.) 

A. It does not log attacks targeting Linux servers. 

B. It matches all traffic to Linux servers. 

C. Its action will block traffic matching these signatures. 

D. It only takes effect when the sensor is applied to a policy. 

Answer: C,D 


Q8. - (Topic 15) 

Review the configuration for FortiClient IPsec shown in the exhibit. 

Which statement is correct regarding this configuration? 

A. The connecting VPN client will install a route to a destination corresponding to the student_internal address object. 

B. The connecting VPN client will install a default route. 

C. The connecting VPN client will install a route to the 172.20.1.[1-5] address range. 

D. The connecting VPN client will connect in web portal mode and no route will be installed. 

Answer:


Q9. - (Topic 7) 

Which antivirus inspection mode must be used to scan SMTP, FTP, POP3 and SMB protocols? 

A. Proxy-based. 

B. DNS-based. 

C. Flow-based. 

D. Man-in-the-middle. 

Answer:


Q10. - (Topic 14) 

In a high availability cluster operating in active-active mode, which of the following correctly describes the path taken by the SYN packet of an HTTP session that is offloaded to a slave unit? 

A. Request: internal host; slave FortiGate; master FortiGate; Internet; web server. 

B. Request: internal host; slave FortiGate; Internet; web server. 

C. Request: internal host; slave FortiGate; master FortiGate; Internet; web server. 

D. Request: internal host; master FortiGate; slave FortiGate; Internet; web server. 

Answer: