300-101 Exam
ccnp routing and switching route 300 101 (11 to 20)
Cause all that matters here is passing the Cisco ccnp dumps 300 101 exam. Cause all that you need is a high score of 300 101 exam ROUTE Implementing Cisco IP Routing exam. The only one thing you need to do is downloading Actualtests ccnp dumps 300 101 exam study guides now. We will not let you down with our money-back guarantee.
P.S. Free 300-101 pdf are available on Google Drive, GET MORE: https://drive.google.com/open?id=1lWZpAR5vb8lOApmzhHWMzXffOPhCR-LL
New Cisco 300-101 Exam Dumps Collection (Question 11 - Question 20)
Question No: 11
A network administrator uses GRE over IPSec to connect two branches together via VPN tunnel. Which one of the following is the reason for using GRE over IPSec?
A. GRE over IPSec provides better QoS mechanism and is faster than other WAN technologies.
B. GRE over IPSec decreases the overhead of the header.
C. GRE supports use of routing protocol, while IPSec supports encryption.
D. GRE supports encryption, while IPSec supports use of routing protocol.
Answer: C
Question No: 12
A router is configured for redistribution to advertise EIGRP routes into OSPF on a boundary router. Given the configuration:
router ospf 1
redistribute eigrp 1 metric 25 subnets
What is the function of the 25 parameter in the redistribute command?
A. It specifies the seed cost to be applied to the redistributed routes.
B. It specifies the administrative distance on the redistributed routes.
C. It specifies the metric limit of 25 subnets in each OSPF route advertisement.
D. It specifies a new process-id to inject the EIGRP routes into OSPF.
Answer: A
Question No: 13
Refer to Exhibit:
Which statement about the configuration on the Cisco router is true?
A. The router sends only NTP traffic, using the loopback interface, and it disables eth0/0 from sending NTP traffic.
B. Eth0/0 sends NTP traffic on behalf of the loopback interface
C. The router sends only NTP traffic, using the eth0/0 interface, and it disables loopback0 from sending NTP traffic.
D. The router never sends NTP traffic, as using the loopback interface for NTP traffic is not supported on IOS routers.
Answer: C
Question No: 14
Which prefix is matched by the command ip prefix-list name permit 10.8.0.0/16 ge 24 le 24?
A. 10.9.1.0/24
B. 10.8.0.0/24
C. 10.8.0.0/16
D. 10.8.0.0/23
Answer: B
Question No: 15
Which command should be added to RTB under router bgp 100 to allow only the external OSPF routes to be redistributed to RTC?
A. redistribute ospf 1
B. redistribute ospf 1 match external 1
C. redistribute ospf 1 match external 2
D. redistribute ospf 1 match external 1 external 2
Answer: D
Explanation:
Use the external keyword along with the redistribute command under router bgp to redistribute OSPF external routes into BGP. With the external keyword, you have three choices: 1. redistribute both external type-1 and type-2 (Default) 2. redistribute type-1 3. redistribute type-2 Enter the commands in the configuration mode as described here: RTB(config-router)# router bgp 100 RTB(config-router)# redistribute ospf 1 match external.
Question No: 16
CORRECT TEXTYou are a network engineer with ROUTE.com, a small IT company. ROUTE.com has two connections to the Internet; one via a frame relay link and one via an EoMPLS link. IT policy requires that all outbound HTTP traffic use the frame relay link when it is available. All other traffic may use either link. No static or default routing is allowed.
Choose and configure the appropriate path selection feature to accomplish this task. You may use the Test Workstation to generate HTTP traffic to validate your solution.
Answer:
We need to configure policy based routing to send specific traffic along a path that is different from the best path in the routing table.
Here are the step by Step Solution for this:
1) First create the access list that catches the HTTP traffic: R1(config)#access-list 101 permit tcp any any eq www
2) Configure the route map that sets the next hop address to be ISP1 and permits the rest of the traffic:
R1(config)#route-map pbr permit 10 R1(config-route-map)#match ip address 101
R1(config-route-map)#set ip next-hop 10.1.100.2 R1(config-route-map)#exit
R1(config)#route-map pbr permit 20
3) Apply the route-map on the interface to the server in the EIGRP Network: R1(config-route-map)#exit
R1(config)#int fa0/1
R1(config-if)#ip policy route-map pbr R1(config-if)#exit
R1(config)#exit
Explanation:
First you need to configure access list to HTTP traffic and then configure that access list. After that configure the route map and then apply it on the interface to the server in EIGRP network.
Question No: 17
A user is having issues accessing file shares on a network. The network engineer advises the user to open a web browser, input a prescribed IP address, and follow the instructions. After doing this, the user is able to access company shares. Which type of remote access did the engineer enable?
A. EZVPN
B. IPsec VPN client access
C. VPDN client access
D. SSL VPN client access
Answer: D
Question No: 18
Which statement about stateless and stateful IPv6 autoconfiguration are true?
A. Both stateless and stateful autoconfiguration require additional setup
B. Stateless autoconfiguration requires no additional setup, whereas stateful autoconfiguration requires additional setup
C. Stateless autoconfiguration requires additional setup, whereas stateful autoconfiguration requires no additional setup
D. Both stateless and stateful autoconfiguration require no additional setup
Answer: B
Question No: 19
Refer to the exhibit.
You have correctly identified the inside and outside interfaces in the NAT configuration of this device. Which effect of this configuration is true?
A. dynamic NAT
B. static NAT
C. PAT
D. NAT64
Answer: C
Question No: 20
Which PPP authentication method sends authentication information in clear text?
A. MS CHAP
B. CDPCP
C. CHAP
D. PAP
Answer: D
Topic 3, Layer 3 Technologies
20.Scenario:
You have been asked to evaluate an OSPF network setup in a test lab and to answer questions a customer has about its operation. The customer has disabled your access to the show running-config command.
How old is the Type 4 LSA from Router 3 for area 1 on the router R5 based on the output you have examined?
A. 1858
B. 1601
C. 600
D. 1569
Recommend!! Get the Free 300-101 dumps in VCE and PDF From Examcollection, Welcome to download: http://www.examcollectionuk.com/300-101-vce-download.html (New 487 Q&As Version)