getcertified4sure.com

Tips for passleader 400 101




Proper study guides for Far out Cisco CCIE Routing and Switching (v5.0) certified begins with Cisco ccie 400 101 preparation products which designed to deliver the Vivid 400 101 dumps questions by making you pass the passleader 400 101 test at your first time. Try the free 400 101 ccie demo right now.

P.S. Vivid 400-101 interactive bootcamp are available on Google Drive, GET MORE: https://drive.google.com/open?id=1TSHirf5GcSZMtvxszMH308yqhbZPjOHA


New Cisco 400-101 Exam Dumps Collection (Question 1 - Question 10)

Q1. Which statement describes Cisco PfR link group?

A. Link groups enable Cisco PfR Fast Reroute when NwtFlow is enabled on the external interfaces of the border routers.

B. Link groups define a strict or loose hop-by-hop path preference.

C. Link groups are required only when Cisco PfR is configured to load-balance all traffic.

D. Link groups are enabled automatically when Cisco PfR is in Fast Reroute mode.

E. Link groups set a preference for primary and fallback (backup) external exit interfaces.

Answer: E



Q2. Which TCP feature allows a client to request a specific packet that was lost?

A. Selective acknowledge

B. Flow control

C. Fast recovery

D. Sliding window

Answer: A



Q3.

Refer to the exhu00edbu00edt. Which statement correctly descru00edptu00edon how a router with this configuration treats packets if it does not know a path 172.16.12.5 and 192.168 3 2?

A. it routes the packet based on the packet's destinatu00edon usu00edng the routu00edng table

B. It drop the packet u00edmmedu00edately

C. It sends an ICMP source quench message

D. it routes the packet Into a loop and drops it when the JTL reaches zero

Answer: A



Q4. Which statement about Cisco StacWise technology is true?

A. AII switches in a stack share configuration and routing informau00feon to behaves a single unit

B. Removing switches can affect stack permance /

C. Every switch in a stack has its own independent ... configuration filewhich enables it to become the stack master if the previious master fails

D. Only the master switch acts as a for Narding processor

Answer: C



Q5. Refer to the exhibit.

What is wrong with the configuration of this tunnel interface ?

A. ISATAP tunnels cannot use the EUI-64 address format.

B. The tunnel source of an ISATAP tunnel must always point to a loopback interface.

C. Router advertisements are disabled on this tunnel interface.

D. No tunnel destination has been specified.

Answer: C



Q6. Refer to the exhibit.

If the route to 10.1.1.1 is removed from the R2 routing table, which server becomes the master NTP

server?

A. R2

B. The NTP server at 10.3.3.3

C. The NTP server at 10.4.4.4

D. The NTP server with the lowest stratum number

Answer: D



Q7. Which three factors does Cisco PFR use to calculate the best exit path?(choose three.

A. Reachability

B. Delay

C. Quality of service

D. Packet size

E. Adminstrative distance

F. Loss

Answer: A,B,F



Q8. Which two statements about IGMP filtering are true?

A. It eliminates the need for a multicast RP.

B. It can be implemented on Layer-3 routed ports using the ipigmp access-list command.

C. It allows Anycast RP to operate within a single AS.

D. It supports IGMPv3 traffic only

E. It can be implemented on Layer-2 switchports using IGMP profiles.

Answer: B,C



Q9. Refer to the exhibit.

Which two conclusions can you draw from this putput?(Choose two)

A. The packet was source-routed.

B. The device that produced the output uses the same interface to send and receive traffic to and

C. from the device at 10.9.132.254

D. The device at 192.168.5.119 is on the same subnet as the next hop for the device at

E. 10.9.132.254

F. The device that produced the output uses different interfaces to send and receive traffic to and

G. from the device at 10.9.132.254

H. The device at the 192.168.5.119 routing table has an ARP entry for the device at 10.9.132.254.

Answer: B,C



Q10. Which command sets the maximum segment size for a TCP packet initiated from a router?

A. ip tcp window-size

B. ip tcp mss

C. ip mtu

D. ip tcp adjust-mss

Answer: B



Recommend!! Get the Vivid 400-101 dumps in VCE and PDF From Examcollection, Welcome to download: http://www.examcollectionuk.com/400-101-vce-download.html (New 911 Q&As Version)