400-101 Exam
Secrets to passleader 400 101
It is more faster and easier to pass the Cisco 400 101 vce exam by using Guaranteed Cisco CCIE Routing and Switching (v5.0) questuins and answers. Immediate access to the Renew 400 101 pdf Exam and find the same core area ccie 400 101 dumps questions with professionally verified answers, then PASS your exam with a high score now.
P.S. Guaranteed 400-101 paper are available on Google Drive, GET MORE: https://drive.google.com/open?id=10qRl3c2aPM7jDirL_NepQ9ytoJQZm2pM
New Cisco 400-101 Exam Dumps Collection (Question 11 - Question 20)
New Questions 11
Refer to the exhibit.
Which tag will be applied to the 172.16.50.0/24 route?
A. 10
B. 20
C. 30
D. 40
Answer: A
New Questions 12
Which feature can you implement to reduce global synchronization?
A. marking
B. NBAR
C. WRED
D. policing
Answer: C
New Questions 13
For which two conditions is Cisco Express Forwarding recursion disables by default when the BGP Prefix independent Convergence functionality is enabled? (Choose two)
A. next hops that are directly connected
B. next hops learned with any mask shorter than /32
C. next hops learned with a/32 mask
D. next hops learned with a/24 mask
Answer: A,C
New Questions 14
Refer to the exhibit.
Which three statements about the R1 configuration are true? (choose three.
A. The virtual circuit identifier is 4006 and the virtual circuit is down.
B. This circuit is using MPLS VC type 4.
C. The local label for the circuit is 1611.
D. The virtual circuit identifier is 1611 and the virtual circuit is down.
E. The targeted LDP session to the remote peer is up.
F. The local label for the circuit is 4006.
Answer: D,E,F
New Questions 15
Which two statements about IPsec VTIs are true? (Choose two)
A. Dynamic VTIs allow you to mix proxy types.
B. The dynamic VTI is a multipoint interface that can support multiple IPsec SAs.
C. The IKE SA can be bound to both the VTI and the crypto map in the router.
D. Static VTIs can use the "IP any any" traffic selector only.
E. The IPsec transform set must be configured in transport mode.
F. Static VTIs can encapsulate both IPv4 and IPv6 packets, but IPv4 can carry IPv4 packets and IPv6 can carry IPv6 packets.
Answer: C,D
New Questions 16
What feature can a device use to identify other members of the same IPv6 multicast group on a network segment?
A. MLD
B. MSDP
C. source-specific multicast
D. rendezvous points
Answer: A
New Questions 17
Refer to the exhibit. R1 has an OSPF path to R2 and R3 for 10.1.0.0/24but R1 has a routing entry for 10.1.0.0/24 from only one router at a time. Which option is the most likely cause?
A. The R1 maximum path is set to 1.
B. R2 has a higher administrative distance.
C. R2 is using a filter list
D. R2 is using an offset list.
Answer: A
New Questions 18
Which option describes a difference between Ansible and Puppet?
A. Ansible is client-server based,and Puppet is not.
B. Ansible requires an agent,and Puppet does not.
C. Ansible is Python based,and Puppet is Ruby based.
D. Ansible autonates repetitive tasks,and Puppet allows you to run plain ssh command.
Answer: C
New Questions 19
What command can you enter to enable client autoconfiguration over an ISATAP tunnel?
A. tunnel mode ipv6ip isatap
B. no ipv6 nd ra suppress
C. ipv6 nd ra suppress
D. tunnel mode ipv6ip 6rd
Answer: B
New Questions 20
Which two statements about VSS are true? (Choose two.)
A. It requires physical switches to be collocated.
B. It is dependent on spanning-tree.
C. It requires three IP addresses per ULAN.
D. Each VSS has a single management IP address
E. It can eliminate the need for HSRP.
Answer: D,E
Recommend!! Get the Guaranteed 400-101 dumps in VCE and PDF From Certifytools, Welcome to download: https://www.certifytools.com/400-101-exam.html (New 911 Q&As Version)