New Questions 5

Refer to the exhibit .

Which action can you take to prevent loops and suboptimal routing on this network?

A. Configure the rfc2328compatibility command under the Cisco IOS OSPF routing process only

B. Configure the rfc2328compatibility command under the Cisco IOS OSPF NX-OS routing process only

C. Configure the ref1583compatibility command under the Cisco NX-OS OSPF routing process only

D. Configure the ref1583compatibility command under the Cisco IOS OSPF routing process only

E. Configure the rfc2328compatibility command Cisco IOS and NX-OS OSPF routing processes

F. Configure the rfc2328compatibility command under the Cisco IOS and NX-OS OSPF routing

New Questions 6

Which IPv6 tunneling type establishes a permanent link between IPv6 domains over IPv4?

A. 6to4 tunneling

B. ISATAP tunneling

C. IPv4-compatible tunneling

D. manual tunneling

New Questions 7

Refer to exhibit.

Which two possible network conditions can you infer from this configuration? (Choose two)

A. R2 is configured as the NTP master with a stratum of 7

B. R1 is using the default NTP source configuration

C. The authentication parameters on R1 and R2 mismatched.

D. RI and R2 have established an NTP session

New Questions 8

Exhibit:

Refer to the exhibit. Which three statements about the output are true? (choose three.)

A. Group 224.0.1.40 is a reserved address , and it should not be used for multicast user data transfer.

B. One or more multicast groups are operating in PIM multicast user data transfer.

C. Group 239.192.1.1 is reserved address, and it should not be used for multicast user data transfer.

D. A multicast receiver has requested to join one or more of the multicast groups.

E. This switch is currently receiving a multicast data stream that is being forwarded out VLAN 150.

F. One or more of multicast data streams will be forwarded out to neighbor 10.85.20.20.

New Questions 9

Which mechanism does GET VPN use to preseNeIP header information?

A. MPLS

B. IPsec transpo mode

C. GRE

D. IPsec tunnel mode

New Questions 10

Refer to the exhibit. Which routes are advertised by the router?

A. BGP routes sourced on this router

B. AII routes

C. BGP routes from AS 65006

D. BGP routes from AS 65006 and BGP routes sourced on this router

E. No routes

New Questions 11

Refer to the exhibit. Which two conclusions can you draw from this command and its output?(choose two)

A. Rl0 has a missing label binding (or 192.168.40.171/32

B. The MPLS ping failed

C. 192.168.40.171/32 exists in the global routing table

D. A valid LSP exists and it matches the corresponding MPLS FEC

E. The MPLS ping was successful

F. R10 has a valid lablel binding for 192.168.40.171/32

New Questions 12

Which two statements about the Cisco Express Forwarding glean adjacency type are true? (Choose two)

A. Packets destined for the interface are discarded and the prefix is checked.

B. The router FIB table maintains a prefix for the subnet instead of individual hosts.

C. The adjacency database is used to [gather specific prefixes when packets are destined to a specific host.

D. Packets destined for the interface can be dropped, which provide a form of access filtering.

E. Packets destined for the interface are discarded and the prefix check is skipped.

New Questions 13

What command can you enter to enable client autoconfiguration over an ISATAP tunnel?

A. tunnel mode ipv6ip isatap

B. no ipv6 nd ra suppress

C. ipv6 nd ra suppress

D. tunnel mode ipv6ip 6rd

New Questions 14

Exhibit:

Refer to the exhibit. If a console port is configured as shown, which response is displayed when you connect to the console port?

A. the message "Authorized users only"

B. the username prompt

C. a blinking cursor.

D. three username name prompts followed by a timeout message.

E. the message "Connection refused."