100-105 Exam
The Secret of 100 105 icnd1 pdf
Breathing of ccent 100 105 free practice questions materials and study guides for Cisco certification for customers, Real Success Guaranteed with Updated ccent 100 105 pdf pdf dumps vce Materials. 100% PASS ICND1 Cisco Interconnecting Cisco Networking Devices Part 1 (ICND1 v3.0) exam Today!
P.S. Breathing 100-105 study guides are available on Google Drive, GET MORE: https://drive.google.com/open?id=1wKeQp_fzylh6B_iOxIFNYB8egVM39bjO
New Cisco 100-105 Exam Dumps Collection (Question 6 - Question 15)
Q6. How many primary ipv4 addresses can be assigned on router interface ?
A. 0
B. 1
C. 4
D. Unlimited
Answer: B
Q7. Which of the following commands enables a network administrator to verify the application layer connectivity between source and destination?
A. ping
B. telnet
C. traceroute
D. verify
E. trace
Answer: B
Q8. Which transport layer protocol is best suited for the transport of VoIP data?
A. RIP
B. UDP
C. TCP
D. OSPF
E. HTTP
Answer: B
Q9. Assuming a subnet mask of 255.255.248.0, three of the following addresses are valid host addresses. Which are these addresses? (Choose three.)
A. 172.16.9.0
B. 172.16.8.0
C. 172.16.31.0
D. 172.16.20.0
Answer: A,C,D
Q10. By default, how many MAC addresses are permitted to be learned on a switch port with port security enabled?
A. 8
B. 2
C. 1
D. 0
Answer: C
Q11. Which statement about native VLAN traffic is true?
A. Cisco Discovery Protocol traffic travels on the native VLAN by default
B. Traffic on the native VLAN is tagged with 1 by default
C. Control plane traffic is blocked on the native VLAN.
D. The native VLAN is typically disabled for security reasons
Answer: A
Q12. Which statement about NTP is true?
A. The default authentication key number is 1.
B. The default source address of an NTP message is the interface connected to the next- hop for the server peer address.
C. The default stratum number is 5.
D. Each device is enabled as a server by default and propagates NTP messages to all peers on its default LAN.
Answer: B
Q13. Which method does a connected trunk port use to tag VLAN traffic?
A. IEEE 802 1w
B. IEEE 802 1D
C. IEEE 802 1Q
D. IEEE 802 1p
Answer: C
Explanation:
IEEE 802.1Q is the networking standard that supports virtual LANs (VLANs) on an Ethernet network. When a frame enters the VLAN-aware portion of the network (a trunk link, for example), a VLAN ID tag is added to represent the VLAN membership of that frame. The picture below shows how VLAN tag is added and removed while going through the network.
http://www.cisco.com/c/en/us/support/docs/lan-switching/8021q/17056-741-4.html
Q14. Which statement about static routes is true?
A. The source interface can be configured to make routing decisions.
B. A subnet mask is entered for the next-hop address.
C. The subnet mask is 255.255 255.0 by default
D. The exit interface can be specified to indicate where the packets will be routed.
Answer: D
Explanation:
Static routing can be used to define an exit point from a router when no other routes are available or necessary. This is called a default route.
Q15. Which Ethernet interface command is present when you boot a new Cisco router for the first time?
A. speed 100
B. shutdown
C. ip address 192.168.1.1 255.255.255.0
D. duplex half
Answer: B
100% Abreast of the times Cisco 100-105 Questions & Answers shared by 2passeasy, Get HERE: https://www.2passeasy.com/dumps/100-105/ (New 347 Q&As)