100-105 Exam
Facts about ccna 100 105
Exambible offers free demo for icnd1 100 105 exam. "ICND1 Cisco Interconnecting Cisco Networking Devices Part 1 (ICND1 v3.0)", also known as ccent ccna icnd1 100 105 exam, is a Cisco Certification. This set of posts, Passing the Cisco icnd 100 105 exam, will help you answer those questions. The ccent ccna icnd1 100 105 pdf Questions & Answers covers all the knowledge points of the real exam. 100% real Cisco ccent 100 105 pdf exams and revised by experts!
P.S. Virtual 100-105 keys are available on Google Drive, GET MORE: https://drive.google.com/open?id=10aMCxNhtGaQ1g5X4WURwuSZDkYQMo5JZ
New Cisco 100-105 Exam Dumps Collection (Question 3 - Question 12)
New Questions 3
Which table displays the MAC addresses that are learned on a switch?
A. FIB
B. ARP
C. TCAM
D. CAM
Answer: D
Explanation: The table is built by recording the source address and inbound port of all frames. As frames arrive on switch ports, the source MAC addresses are learned and recorded in the CAM table. The port of arrival and the VLAN are both recorded in the table, along with a timestamp. If a MAC address learned on one switch port has moved to a different port, the MAC address and timestamp are recorded for the most recent arrival port. Then, the previous entry is deleted. If a MAC address is found already present in the table for the correct arrival port, only its timestamp is updated.
New Questions 4
Which command is used to build DHCP pool?
A. ipdhcp conflict
B. ipdhcp-server pool DHCP
C. ipdhcp pool DHCP
D. ipdhcp-client pool DHCP
Answer: C
New Questions 5
Which NAT command can be applied to an interface?
A. ip nat inside
B. ip nat inside test access-list-number pool pool-name
C. ip nat inside source static 10.10.10.0 10.10.10.50
D. ip nat pool test 10.10.10.0 10.10.10.50 255.255.255.0
Answer: D
New Questions 6
In which circumstance is static routing most useful?
A. on a stub network
B. on a network with frequent routingchanges
C. on a network that experiences frequent link failures
D. on a large network that must share routes quickly between routers
Answer: A
New Questions 7
Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?
A. dual stack XX
B. dynamic
C. Teredo
D. Manual 6to4
Answer: C
New Questions 8
How many primary IPv4 addresses can be assigned to an interface?
A. unlimited
B. 8
C. 2
D. 1
Answer: A
Explanation:
CiscoIOS software supports multiple IP addresses per interface. You can specify an unlimited number of secondary addresses.
New Questions 9
On which type of device is every port in the same collision domain?
A. a router
B. a Layer 2 switch
C. a hub
Answer: C
Explanation: Collision domainA collision domain is, as the name implies, a part of a network where packet collisions can occur. A collision occurs when two devices send a packet at the same time on the shared network segment. The packets collide and both devices must send the packets again, which reduces network efficiency. Collisions are often in a hub environment, because each port on a hub is in the same collision domain. By contrast, each port on a bridge, a switch or a router is in a separate collision domain.
New Questions 10
Which statement describes the effect of the copy run start command on a router in enable mode?
A. The running configuration of the router is saved to NVRAM and used during the boot process.
B. The router reboots and loads the last saved running configuration.
C. A copy of the running configuration of the router is sent by FTP to a designated server.
D. A new running configuration is loaded from flash memory to the router.
Answer: A
New Questions 11
Which entity assigns IPv6 addresses to end users?
A. ICANN
B. APNIC
C. RIR
D. ISPs
Answer: C
New Questions 12
Refer to the exhibit.
What does the address 192.168.2.167 represent?
A. the TFTP server from which the file startup-config is being transferred
B. the router from which the file startup-config is being transferred
C. the TFTP server from which the file router-confg is being transferred
D. the TFTP server to which the file router-confg is being transferred
E. the router to which the file router-confg is being transferred
F. the router to which the file startup-config is being transferred
Answer: D
P.S. Easily pass 100-105 Exam with Thedumpscentre Virtual Dumps & pdf vce, Try Free: http://www.thedumpscentre.com/100-105-dumps/ (347 New Questions)