New Questions 6

An MOH server is configured to stream a local .wav file that is located on its own hard disk drive. An external caller reports that they can only hear the TOH when they are placed on

hold. Which two could be the problem? (Choose two.)

A. The sound card is missing from the server.

B. The music CD is corrupted.

C. Insufficient bandwidth is configured.

D. Unicast streams exceeded the maximum that was configured.

New Questions 7

How many active gatekeepers can you can define in a local zone?

A. 1

B. 2

C. 5

D. 10

E. 15

F. unlimited

New Questions 8

Refer to the exhibit.

To permit three G.729 calls, what should the bandwidth value be for the ip rsvp bandwidth command?

A. 32

B. 48

C. 64

D. 88

E. 128

New Questions 9

What impact do roaming-sensitive settings and Device Mobility settings have on call routing?

A. Device Mobility settings have no impact on call routing, but roaming-sensitive settings modify the AAR group, AAR CSS, and device CSS.

B. Device Mobility settings modify the device CSS and the roaming-sensitive settings modify the AAR group and AAR CSS.

C. Device Mobility settings modify the AAR group and the AAR CSS, the roaming-sensitive settings modify the device CSS.

D. Roaming-sensitive settings are settings that do not have an impact on call routing. Device Mobility settings, on the other hand, may have an impact on call routing because they modify the device CSS, AAR group, and AAR CSS.

New Questions 10

When an external call is placed from Ajax, they would like the ANI that is sent to the PSTN to be the main number, not the extension. For domestic calls, they would like 10 digits sent; for international calls, they would like to send the country code 1 and the 10 digits. How can this be accomplished?

A. Add a translation pattern to the dial peers in the gateway that adds the appropriate digits to the outgoing ANI.

B. In the external call route patterns, set the external phone number mask to the main number. Use 10 digits in the domestic route pattern and 1 followed by the main number digits in the international route patterns.

C. Use a calling party transform mask for each route group in the corresponding route list configuration. Set the explicit 10-digit main number for domestic calls and 1 followed by the main number for the international route patterns.

D. In the directory number configurations, set the prefix digits field to the country code and the 10 digits of the main number. This will be truncated to the 10-digit number for domestic calls and sent out in its entirety for international calls.

New Questions 11

Which system configuration is used to set a restriction on audio bandwidth?

A. region

B. location

C. physical location

D. licensing

New Questions 12

Refer to the exhibit.

Which statement about the configuration between the Default and BR regions is true?

A. Calls between the two regions can use either 64 kbps or 8 kbps.

B. Calls between the two regions can use only the G.729 codec.

C. Only 64 kbps will be used between the two regions because the link is "lossy".

D. Both codecs can be used depending on the loss statistics of the link. When lossy conditions are high, the G.711 codec will be used.

New Questions 13

Refer to the exhibit.

Which configuration change is needed to enable NANP international dialing during MGCP fallback?

A. Change the dial peer to dial-peer voice 901 voip.

B. Change the dial peer to dial-peer voice 9011 pots.

C. Add the command prefix 011 to the dial peer.

D. Add the command prefix 9011 to the dial peer.

New Questions 14

Which two features require or may require configuring a SIP trunk? (Choose two.)

A. SIP gateway

B. Call Control Discovery between a Cisco Unified Communications Manager and Cisco Unified Communications Manager Express

C. Cisco Device Mobility

D. Cisco Unified Mobility

E. registering a SIP phone

New Questions 15

Refer to the exhibit.

A PSTN call arrived at the MGCP gateway. The calling number was received as 14087071222 with number set to type international. The HQ_clng pty_CSS contains the HQ_clng_pty Pt partition. Which caller ID is displayed on the IP phone?

A. +087071222

B. 14087071222

C. 087071222

D. 4087071222

E. 14087071222