200-125 Exam
Key benefits of cisco ccna 200 125
Act now and download your Cisco ccna routing and switching 200 125 official cert guide library test today! Do not waste time for the worthless Cisco ccna routing and switching 200 125 pdf tutorials. Download Down to date Cisco CCNA Cisco Certified Network Associate CCNA (v3.0) exam with real questions and answers and begin to learn Cisco 200 125 cisco with a classic professional.
P.S. Validated 200-125 class are available on Google Drive, GET MORE: https://drive.google.com/open?id=1qSmqe9lmg23sR5XECqlhobCqcIIdpdHn
New Cisco 200-125 Exam Dumps Collection (Question 4 - Question 13)
Question No: 4
How does NAT overloading provide one-to-many address translation?
A. it uses a pool of addresses.
B. it converts IPv4 addresses to unused IPv6 addresses.
C. it assigns a unique TCP/UDP port to each session.
D. it uses virtual MAC address and virtual IP addresses.
Answer: C
Question No: 5
Which IPV6 function serves the same purpose as ARP entry verification on an IPv4 network?
A. interface ip address verification.
B. MAC address table verification
C. neighbor discovery verification
D. routing table entry verification
Answer: C
Question No: 6
What is one requirement for interfaces to run IPv6?
A. An IPv6 address must be configured on the interface.
B. An IPv4 address must be configured.
C. Stateless autoconfiguration must be enabled after enabling IPv6 on the interface.
D. IPv6 must be enabled with the ipv6 enable command in global configuration mode.
Answer: A
Explanation: To use IPv6 on your router, you must, at a minimum, enable the protocol and assign IPv6 addresses to your interfaces.
Question No: 7
Which option is the main function of congestion management ?
A. providing long term storage of buffered data
B. queuing traffic based on priority
C. discarding excess traffic
D. classifying traffic
Answer: B
Question No: 8
which value must you configure on a device beforee EIGRP For IPV6 Can start Running ?
A. Process ID
B. Router ID
C. Public IP Address
D. Loopback interface
Answer: B
Question No: 9
Which type of attack can be mitigated by configuring the default native vlan to be unused ?
A. swich spoofing
B. cam table overflow
C. vlan hopping
D. MAC spoofing
Answer: C
Question No: 10
When you deploy multilink PPP on your network, where must you configure the group IP Address on each device?
A. In the global config
B. Under serial interface
C. Under the routing protocol
D. Under the multilink interface
Answer: D
Question No: 11
A network administrator has configured access list 173 to prevent Telnet and ICMP traffic from reaching a server with the address of 192.168.13.26. Which commands can the administrator issue to verify that the access list is working properly? (Choose three.)
A. Router# ping 192.168.13.26
B. Router# debug access-list 173
C. Router# show open ports 192.168.13.26
D. Router# show access-lists
E. Router# show ip interface
Answer: A,D,E
Question No: 12
To enable router on a stick on a router subinterface, which two steps must you perform ? choose two
A. configure full duplex and speed
B. configure a default to route traffic between subinterfaces
C. configure the subinterface with an ip address
D. configure encapsulation dot1q
E. configure an ip route to the vlan destination network
Answer: C,D
Question No: 13
which option is the correct CIDR notation for 192.168.0.0 subnet 255.255.255.252?
A. /29
B. /30
C. /31
D. /32
Answer: B
P.S. Easily pass 200-125 Exam with Allfreedumps Validated Dumps & pdf vce, Try Free: https://www.allfreedumps.com/200-125-dumps.html (573 New Questions)